KSB Sealless Chemical Pump 600 l/h 1/3HP 3/8" NPT, Self-Priming Monoblock

Description

Manufacturer:
KSB
Model
: CSA-10/1 Laboratory Pump, sealless, canned motor, monoblock, self-priming
Motor
: 1/3 HP, 0.22 KW, 3500 RPM
Voltage:
3 phase, 220-380V 50Hz (208V 60Hz)
Maximum Pressure
: 10 bar at 120 deg C
Inlet/Outlet Size:
3/8" NPT
Capacities up to:
600 l/h
Head:
up to 36m
Temperature Range
: -5°C to 180°C
NPSH required (constant):
1.50 m
APPLICATIONS
Recommended for use in process that carry
hazardous and harmful substances and must be
completely sealed to the external environment
Pumping and transfert of various chemicals (clear, without solids)
Solvents, hydrocarbons, antifreeze, trichloroethane…
Acids (sulfuric, nitric, acétic… )
Alkaline solutions (sodium, potassium, ammonia… )
Oxygenated water, demineralized water
Refrigerants
CONSTRUCTION SPECIFICATIONS
Monobloc pump
Ring section self priming pump
One Peripheral impeller
Suction casing and discharge caising assembled by tie bolts
Bearing bracket support and pump shaft mounted on plain bearings.
Without sealing system
Coupling between pump and motor shafts
Casing, impeller and shaft in stainless
steel
Front and rear plate with can in stainless
steel
Graphite plain bearing
Gasket in teflon
MOTOR
Normalized
Insulation class: E
Enclosure : IP 55
A wet rotor unit on self lubricated graphite sleeve bearing.
Cast iron carcass, induced short-circuit.
Sealess with sealed terminal box.
Insolating class « F »(155°C).
Stator chamber filled with insulating oil, isolated from the can
Direction of rotation and pump filling checked by glass sight
This is a new old stock surplus pump that was not put into service. It has minor signs of storage wear but is new and unused. The electrical connector installed on the power cable was specific to an order for a particular job. Thus, you may decide to modify the connection on the cable for your own needs.